Use at speeds under 6,000 RPM on sanders, polishers, and grinders.

Be sure that Swirl-Off® unit is properly positioned on power tool.
Retainer cup must be tightly secured by locking nut.

Wear goggles, dust mask, and other personal protective equipment
at all times.

Do not run over cables and hoses with the cutter assembly.

Turn off the power supply when doing repair
or maintenance on the machine.

Follow all safety recommendations power unit manufacturer suggests.

Replace cutters when worn. Before operation make sure that
the complete cutter set is properly installed.

When working under water or near water use only pneumatic
or hydraulic powered tools. For underwater 1,000 to 2,000 RPM
is suggested. (Do not use electric tools in or near water)

Do not use in flammable or combustible environment.

The performance of your Swirl-Off® tool is dependent on the power
it receives from your disck sander, grinder, polisher, or drill motor.
The tool will give its utmost performance when a disc sander with
speeds from 1500 to 4000 RPM is used, but not over 6,000 RPM.

Do not press the tool too hard against the surface to be cleaned as
the cutters will do the job. Hold the tool flat on the surface. Wear
safety goggles and a dust mask.

If material clogs housing, stop unit and tap against a hard surface.
If housing is clogged cutter teeth could flatten.